A generator with a starting problem often leaves you without a power source to run the items you need most. A DuroMax generator bogs down and runs rough under load when too much load is applied for the size of the generator, the carburetor is dirty, the fuel filter is clogged, the air filter is …
Generators
Many of the problems you may experience as a generator owner can be from using old gas. DuroMax generators use unleaded gasoline with a minimum 87-octane rating and a maximum 10% ethanol content. Wait for the generator to cool down before refueling. Always remove the cap slowly in case the tank is under pressure. Refuel …
Maintaining your generator by completing oil changes, changing out filters, and keeping it clean will help minimize issues. However, when you own a generator long enough, chances are you’ll run into some type of problem. To help when that happens, I have put together troubleshooting tables to identify the cause of many common Pulsar generator …
When your generator quits running, you need to get it fixed or you’re most likely without a power source. I’ve put together a list of things to check to get your generator running again. A Pulsar generator starts and then dies due to an empty fuel tank, plugged fuel filter, dirty carburetor, clogged fuel line, …
When your generator won’t start, chances are it’s at a time when it’s your only power source. I’ve put together this list to help you troubleshoot your starting problem. A DuroMax generator won’t start due to a dirty carburetor, plugged fuel filter, plugged fuel tank vent, bad spark plug, plugged air filter, wrong choke setting, …
This guide is to help you quickly identify the cause of your generator problem so you can fix it and get it back running again. It’s important to maintain your generator to keep it in good condition. This includes performing an annual service and performing routine checks and cleanings. This will help minimize issues and …
When your generator just quits running and leaves you without a power source, you need to find and fix the problem quickly. I put together this guide to help! A Champion generator starts then dies due to an empty fuel tank, plugged fuel filter, dirty carburetor, clogged fuel line, bad gas cap, dirty spark plug, …
When the engine doesn’t run strong and begins to bog down, shut off the generator and troubleshoot it using the information below. Continuing to run the generator in this condition may not only damage the generator, but also damage the items connected to it. A Pulsar generator bogs down under load when too much load …
You’re using a generator when you don’t have an alternative power source. So when it stops running, you need to get it fixed as quickly as possible to power the items you need most. A Pulsar generator won’t stay running when it is overloaded, low on engine oil, or isn’t getting sufficient air, fuel, and …
Chances are your generator quit running at the worst time. That’s why I put together this list to help you diagnose and repair your running problem. A Champion generator won’t stay running when it is overloaded, low on engine oil, or isn’t getting sufficient air, fuel, and spark. This may be due to a plugged …