Skip to Content

5 Common Husqvarna Leaf Blower Problems (Troubleshoot)

You rely on your leaf blower for fall cleanup, to clear debris off the patio, or for numerous other applications. When it fails to work right, your job can be increasingly more difficult when you have to grab a lawn rake or a push broom.

To help you identify common Husqvarna leaf blower problems so you can perform troubleshooting procedures, I have put together charts with links providing information in more detail.

Always follow the safety procedures found in your Husqvarna operator’s manual. This includes waiting for the engine to cool and for all parts to stop moving. Remove the spark plug wire prior to performing repairs.

Common Husqvarna Leaf Blower Problems:

  • Leaf blower won’t start
  • Leaf blower starts then dies
  • Leaf blower runs rough and sputters
  • Leaf blower only runs with the choke on
  • Leaf blower loses power and bogs down
Common Husqvarna Leaf Blower Problems

This post may include affiliate links. Purchases made through these links may provide a commission for us, at no extra cost to you. As an Amazon Associate, we earn from qualifying purchases.

Follow all safety instructions provided in your equipment operator’s manual prior to diagnosing, repairing, or operating. Consult a professional if you don’t have the skills, or knowledge or are not in the condition to perform the repair safely.

Common Husqvarna Leaf Blower Problems & Solutions

1. Husqvarna Leaf Blower Won’t Start

To troubleshoot a starting problem, look at the items that restrict air, fuel, and spark. These are the three requirements for combustion.

Make sure you are running fresh fuel with a gas-to-oil ratio of 50:1. Choose a gas that has a minimum 89-octane rating and a maximum ethanol content of 10%. Mix with a premium 2-cycle engine oil like Husqvarna XP.

Never run straight gas through the blower. This will permanently damage the engine. Gas runs extremely dry and doesn’t provide lubrication to the engine.

Detailed information can be found at:
Reasons Your Husqvarna Leaf Blower Won’t Start

CauseReason for the ProblemSolution
Bad or old fuelFuel breaks down over time making the fuel less efficient and prone to clogging the fuel system.Drain the fuel tank and fill it with fresh gas and 2-cycle oil. mix at a ratio of 50:1. Use a fuel additive like Sea Foam to stabilize the fuel and assist with cleaning the fuel system. Use the right fuel.
Incorrect 2-cycle oil mixAn incorrect mix can fail to provide the lubrication the engine requires.Mix gas and 2-cycle oil at a rate of 50:1. Use gas with a minimum 89-octane rating and maximum 10% ethanol content.
Bad spark plugA dirty or damaged spark plug; loose spark plug wire, or incorrect gap can prevent the engine from starting. Replace with a new spark plug, secure connections, and ensure it is gapped to manufacturer specifications
Plugged air filterDirt can plug the air filter preventing airflowRemove the filter and clean it. Replace the filter if it is in bad condition.
Plugged fuel filterA dirty fuel filter will restrict fuel flow.Replace the fuel filter.
Blocked fuel linesDeposits left behind by old fuel and dirt can clog the fuel lines preventing the engine from getting fuel.Use a carburetor cleaner and compressed air to clear the clog out of the fuel line. Replace the line if necessary.
Plugged fuel tank ventA plugged fuel tank vent will no longer allow the tank to vent. A vacuum will form keeping fuel to flow out of the tank.Replace a plugged fuel tank vent.
Plugged spark arrestorHot air isn’t able to exit the leaf blower when the spark arrestor is plugged with soot.Clean the spark arrestor screen.
Dirty carburetorThe carburetor can become dirty and clogged due to bad fuel and ethanol deposits preventing fuel flow.Clean the components making up the carburetor. Replace it if needed.
Bad primer bulbA cracked primer bulb will fail to move fuel to the carburetor.Replace the primer bulb
Flooded engineThe fuel-to-air mixture is running too rich that it can’t ignite. This can be caused by pressing the primer bulb too many times or pulling the starter rope too many times while the choke is closed.Turn the switch to the run position. Move the choke lever to the run position. Press the throttle trigger while pulling the starter rope over and over.
Broken starter recoilA damaged or broken recoil prevents the recoil from starting your engine.Check the recoil to see if it can be restrung. Broken parts must be replaced. Replace the recoil assembly if needed.
Reasons for Husqvarna Leaf Blower Starting Problems

2. Husqvarna Leaf Blower Starts Then Dies

Many of the items that prevent a Husqvarna leaf blower from starting are also the same items that can cause it to stall and die after it’s been running.

If the blower starts and then dies right away, make sure you are starting it correctly. The choke lever must be placed in the on position to restrict airflow to start a cold engine.

Once the engine warms, it must be placed in the off position or the engine will no longer run.

Detailed information can be found at:
Your Husqvarna Leaf Blower Starts, Stalls and Dies

CauseReason for the ProblemSolution
Wrong choke settingThe engine will die when the choke lever isn’t placed in the open position after the engine warms.Close the choke to restrict air to start a cold engine. Open it once the engine warms.
Bad fuelFuel breaks down over time making your fuel less efficient and prone to clogging the fuel system and engine damage.Drain the fuel tank and fill it with fresh fuel and 2-cycle engine oil mixed at a ratio of 50:1. Use a fuel additive like Sea Foam to stabilize the fuel and assist with cleaning the fuel system.
Plugged air filterDirt can plug the air filter preventing airflow.Remove the filter and clean it. Replace the filter if it is in bad condition.
Plugged fuel filterA plugged fuel filter won’t allow sufficient gas to pass through it.Replace the fuel filter
Clogged fuel linesBad fuel deposits and dirt can build up and clog the fuel lines preventing the engine from getting the required fuel.Use a carb cleaner and compressed air to clear the clog out of the fuel line
Dirty carburetorThe carburetor can become dirty and clogged due to bad fuel and ethanol deposits preventing fuel flowClean all the components making up the carburetor. Rebuild or replace if needed.
Plugged fuel tank ventA plugged fuel tank vent will no longer allow the tank to vent. A vacuum will form keeping fuel to flow out of the tank.Replace a plugged fuel tank vent.
Plugged spark arrestorThe spark arrestor can plug with soot so hot air can no longer exhaust.Remove the spark arrestor screen and clean it with a metal brush. Replace a damaged screen
Reasons a Husqvarna Leaf Blower Starts, Stalls and Dies

3. Husqvarna Leaf Blower Runs Rough and Sputters

A dirty carburetor is often the reason your Husqvarna blower begins to run rough and sputter. This is common when old gas clogs the fuel passageways.

Another common item that can cause this is a plugged spark arrestor that won’t allow hot exhaust air to leave the engine.

Detailed information can be found at:
Your Husqvarna Leaf Blower Runs Rough

CauseReason for the ProblemSolution
Old fuelOld fuel leaves behind gummy deposits that can restrict fuel and cause component failure.Remove old fuel and replace it with fresh gas and 2-cycle engine oil mix at a ratio of 50:1. Add a fuel additive like Sea Foam Motor Treatment to stabilize gas and clean the fuel system.
Dirty spark plugThe intermittent spark from a dirty spark plug can cause it to run sluggishly.Replace the spark plug.
Plugged fuel filterA good flow of fuel is not able to pass through a plugged fuel filter.Replace the fuel filter.
Clog fuel linesFuel is restricted when the fuel line develops a clog due to old fuel or dirt.Clean or replace the fuel line.
Plugged fuel tank ventWhen the fuel tank is unable to vent, it forms a vacuum that keeps fuel from leaving the tank.Replace the fuel tank vent.
Plugged air filterThe air filter can become plugged with so much dirt that sufficient air isn’t able to pass through it.Replace the air filter.
Dirty carburetorFuel passageways in the carburetor become plugged with old gas deposits keeping sufficient fuel from getting to the engine.Remove the carburetor and clean it. Rebuild or replace it if needed.
Plugged spark arrestorHot exhaust air isn’t able to exit the blower when the spark arrestor is plugged with carbon buildup.Remove and clean the spark arrestor screen.
Reasons a Husqvarna Leaf Blower Runs Rough and Sputters

4. Husqvarna Leaf Blower Runs With the Choke On

The choke is used to restrict airflow. Your choke may need to be used once the engine is warm to correct the fuel and air mixture to keep the blower running.

When your Husqvarna leaf blower only runs with the choke on, look for items that can cause the engine to get too much air or not enough fuel.

Detailed information can be found at:
Your Husqvarna Leaf Blower Only Runs with the Choke On

CauseReason for the ProblemSolution
Old fuelOld fuel can leave behind varnish and deposits that cause fuel restrictions and fuel component failures.Drain the fuel tank. Refill with fresh gas and 2-cycle oil mixed at a ratio of 50:1. Add a fuel stabilizer and fuel system cleaner. Start and allow the fuel to work its way through the fuel system.
Fuel line punctureAir can be sucked into the line increasing the amount of air getting to the engine.Replace the fuel line. Check for fuel line restrictions.
Plugged fuel filterA dirty plugged air filter restricts airflow.Replace the air filter.
Bad carburetor gasketThe gasket may no longer seal allowing excess air into the carburetor.Remove the carburetor and replace the gasket.
Dirty carburetorFuel passages can clog and no longer allow sufficient gas for the combustion process.Remove and clean the carburetor. Rebuild or replace it if needed.
Plugged fuel tank ventA plugged fuel tank vent will cause a vacuum to form in the fuel tank. This will keep fuel from flowing out of the tank.Replace the fuel tank vent.
Reasons a Husqvarna Leaf Blower Only Runs with the Choke On

5. Husqvarna Leaf Blower Loses Power and Bogs Down

When a Husqvarna blower isn’t giving you good power or is bogging down, the cause is often a dirty carburetor and other items that are restricting fuel.

Other items to check are those that keep hot air from exiting the blower, air from getting to the engine, or spark problems.

Detailed information can be found at:
Reasons Husqvarna Leaf Blower Loses Power & Bogs Down

CauseReason for the ProblemSolution
Old fuelOld fuel can leave behind varnish and deposits that cause fuel restrictions and fuel component failures.Drain the fuel tank. Refill with fresh gas and 2-cycle oil mixed at a ratio of 50:1. Add a fuel stabilizer and fuel system cleaner. Start and allow the fuel to work its way through the fuel system.
Plugged air filterGood airflow cannot pass through a plugged air filter.Replace the air filter.
Dirty spark plugA dirty spark plug can cause an intermittent spark.Clean or replace the spark plug.
Plugged fuel filterSufficient fuel is unable to pass through a plugged filter.Replace the fuel filter.
Clogged fuel lineClogged fuel lines can keep fuel from getting to the carburetor.Try to clean the fuel line or replace it.
Plugged fuel tank ventA plugged fuel tank vent will cause a vacuum to form in the fuel tank. This will keep fuel from flowing out of the tank.Replace the fuel tank.
Plugged spark arrestorThe spark arrestor can plug with soot so hot air can no longer exhaust.Remove the spark arrestor screen and clean it with a wire brush.
Carbon buildup on the exhaust portCarbon that builds up in the exhaust port and hot air isn’t able to exit through the muffler.Clean the exhaust port.
Dirty carburetorFuel passages can clog and no longer allow sufficient gas for the combustion process.Clean the carburetor to remove varnish left behind by old fuel. Rebuild or replace it if necessary.
Reasons a Husqvarna Leaf Blower Loses Power & Bogs Down

Don’t Skip Maintenance on Your Husqvarna Leaf Blower

While you will experience a problem with your Husqvarna blower at some time, you can minimize significant problems by performing regular routine service.

I recommend completing a full maintenance service on your Husqvarna blower once a year to keep it in good condition.

The annual service includes replacing the maintenance parts: air filter, fuel filter, and spark plug. You should also check the fuel system and cooling system, and clean the exterior.

Tighten any loose hardware and replace any damaged or missing parts. In addition to this, you must inspect the blower before use to make sure it is in good condition before operating.